I am new here and need some information, I purchased some new sealed VIX500IM drives for a CNC retrofit and need to get them into step and dir mode.
I have configured the drive with my motor which runs with a program.
I found the document How to program an intelligent VIX stepper as a step & direction.
1LIMITS(3,0,0) ;DO NOT USE LOCAL LIMITS
1W(ES,0) ;X4.11 LOW=ENERGIZE, HIGH (OPEN CIRCUIT) = SHUTDOWN
1W(EI,0) ;STEP AND DIR INPUT MODE
1MP ;STEP AND DIRECTION BASE DRIVE MODE
I also have the motor parameters and communication parameters in the config.
I am apparently missing something.