F11 Stegmann SinCos Hyperface encoder option replaced by F10 option

The following part numbers are impacted:

SxxxVxF11IxxTxxMxx

HxxxV4F11IxxTxxMxx

MxxxD6F11IxxTxxMxx

(xx equals any valid option for these models)

All custom products based on the above products

The Compax3 has been available with three different Feedback option codes:

F10  - Standard resolver feedback support
F11 -  SinCos© (Hiperface)
F12 -  Quadrature encoder, 1Vpp sinecosine, Endat 2.1

As of July 1, 2018, the new options will be as follows:
F10  - Standard resolver feedback support & SinCos© (Hiperface)
F12 -  Quadrature encoder, 1Vpp sinecosine, Endat 2.1

Availability

The F11 option code will be disabled effective immediately. F10 option code is a direct replacement.

No changes need in terms of the configuration file in the C3 ServoManager software, firmware within the drive, cable or motor.

Suggested Replacements  

In all cases the F11 can be replaced by the F10 option. For example, model number

S025V2F11I31T11M00   should now be ordered as   S025V2F10I31T11M00

Customers with existing Compax3 project files for F11 models can download the files directly to F10 drives without modification. In new applications that require SinCos© (Hiperface) feedback, user can simply select F11 in the device selection wizard when configuring the drive. This will allow the user to configure the drive for a motor with SinCos© (Hiperface) feedback.

This simplifies the ordering to only 2 feedback options F10 or F12.