Follow Parker Hannifin on social media:
PAC320 does not start after power cycle and cannot be connected to via Ethernet.
1. Solid Blue
2. Flashing White
3. Solid Red
In order to get it running after each power cycle I have to:
1. power the PAC off
2. remove the SD card
3. delete the application and the .crc file from the SD card
4. replace the SD card and power on the PAC
5. connect to the PAC with Parker Automation Manager and download the application
I need to have the PAC boot the application after power up and switch to run mode automatically. Any idea what might be preventing that from happening?
Dean... It seems like something in the application is crashing the PAC. Common things to look for would be infinite loops within a scan and divide by Zero issues. If after going through your code, you cannot find an issue, please create a project archive and send it to firstname.lastname@example.org
Thank you for the response. The irritating problem is that the application runs fine until power to the PAC is interrupted. It is only after the power cycle that the error condition mentioned above occurs. I will email the archive to the support group.