Your 690+ MUST have firmware version 4.X or higher to have the ability to clone the the drive and both drives MUST be the same rating. The drive that you are cloning to must have the same or higher firmware as the original drive.
To copy the parameters to the keypad you mush go to SYSTEM > SAVE CONFIG > SAVE CONFIG > OP STATION
This information is also found in the manual. Follow this QuickLink for the 690+ on Parker.com - (Manual, QuickStarts, Product Support, etc)
To load parameters to the new drive you must go to SYSTEM > SAVE CONFIG > RESTORE CONFIG > OP STATION
To save these new parameters to the drive you must go to SYSTEM > SAVE CONFIG > APPLICATION
Created: 9/21/2018 STV